Tundra Remote Door Lock Reprogram

Once your car is in programming mode with the remote you are trying to program press the unlock and lock buttons simultaneously for about 2 seconds then release and press just the lock button for 1 second.

Tundra remote door lock reprogram.

Press and hold lock and unlock button for 1 5 seconds. Using the door control pad located on the driver s side door press the lock and unlock buttons for five passes. After 10 seconds push the same lock unlock or panic button on the transmitter twice within 10 seconds. To program the new toyota key fob hold the unlock and lock button on the key fob for two seconds and then release.

Press and release lock or unlock button. If they cycle twice repeat this step again. Close and then open the driver s side door. With the driver s side door open.

System should now lock and unlock vehicle once to confirm registration twice to indicate registration has failed. Within three seconds the locks should cycle once to show that it the procedure was successful. Then press the lock button for up to three seconds and release. You should hear a beep letting you know that the procedure was done correctly.

Change the position to door make sure all the doors are shut and that your shift lever is set to park put the key in the ignition and turn it so it is set to on once you are in the on position and before 5 seconds has passed push down the door lock switch on the driver s side keeping it down for 5 seconds. Within 5 seconds insert the ignition key again and turn it to the on position. If you are programming multiple remotes repeat step 8 for each remote within 40 seconds of step 7. The locks should cycle once to verify that the car has accepted your remote.

Each set represents one pass. Release the buttons and immediately press and hold the lock button for two seconds. Unlock the driver s side door. Quickly insert and then remove your key from the ignition switch.

Within 10 seconds the door locks should lock and then unlock once indicating successful programming. Within 3 seconds the door locks should lock and then unlock once indicating successful programming. Press the lock and unlock buttons on the new remote simultaneously for 1 1 2 seconds. Immediately after letting go of the lock and unlock buttons press and hold the lock button by itself.

The door should lock and unlock. Insert the ignition key and remove it. Repeat button procedure to program remaining remote transmitters.